Print ISSN: 1812-1217

Online ISSN: 1998-0345

Keywords : Tensile bond strength


Comparison of Tensile Bond Strength Between Fissure Sealants Placed After Rubber Cup Polishing and Air Polishing of Enamel Surface (An in vitro study)

ibrahim Basheer Badran; Saher Sami

Al-Rafidain Dental Journal, 2021, Volume 21, Issue 1, Pages 124-134
DOI: 10.33899/rden.2020.128036.1048

Aims: The purpose of this study is to compare the tensile bond strength between fissure sealants placed after rubber cup  pumice polishing and air polishing of the enamel surface. Materials and Methods: An experimental study was carried out using 40 non-carious upper first premolars extracted for an orthodontic reason, the crowns were separated from the roots, the teeth were randomly divided into 2 main groups consisting of 20 crowns depending on the sealant material used (Prevent or Angie), the teeth were subdivided into two subgroups of 10 teeth depending upon whether rubber cup with pumice slurry polishing or air polishing. Group Ia: Prevent Rubber cup (PRC). Group Ib : Prevent Air polisher (PAP), Group IIa: Angie Rubber cup (ARC). Group IIb: Angie Air polisher (AAP). Each tooth in this study was etched with a 37% semi-gel phosphoric acid for 15 seconds on the buccal surface, rinsed thoroughly for 20 seconds, and dried with the air stream to get an uniformly white, chalky-similar appearance. A translucent plastic tube was fixed on an etched enamel surface and filled incrementally with a fissure sealant then ready small post screws with twisted orthodontic wire gauge 0.012 inches which placed inside the tube until the serrations of screws were embedded in the last increment and light-cured. Samples were kept in the distilled water at room temperature for 24 hours. Tensile bond strength was measured by using the universal testing machine (GESTER, GT-C04-2, CHINA) and the values were statistically analyzed using Independent sample t-test. Results: A non-significant difference in tensile bond strength was detected between two methods used in the groups (p>0.05). Conclusions: The air polishing method is easy and useful but, there were no significant differences  on the tensile bond strength of material  in comparison with a rubber cup and pumice.

Effect of Different Curing Methods on Tensile bond Strength Soft Acrylic Liner to Heat-Cured Acrylic Resin

Alaa Al-Saraj; Marwah M Shehab; Reem N Al- Irhaym

Al-Rafidain Dental Journal, 2011, Volume 11, Issue 2, Pages 292-296
DOI: 10.33899/rden.2011.9090

Aims: To evaluate the effect of different curing methods on tensile bond strength between soft acrylic liner and heat cured acrylic resin denture base. Materials and methods: Twenty four specimens were prepared form Vertex heat cured acrylic resin and divided into four groups: cured by water bath ,treated by monomer and cured by water bath ,cured by domestic microwave oven and treated by monomer and the last group cured by domestic microwave oven at same setting. Instron tensile testing machine was used for tensile bond strength test . Results: There is a significant differences between tensile bond strength of tested groups (p=0.001) for the different curing methods. Conclusions: The curing of soft acrylic liner by water bath had better tensile bond strength compared to microwave curing.